Add two tests to deslave a port from and reenslave to a bridge. This should
retain the ability of the system to forward traffic, but on an offloading
driver that is sensitive to ordering of operations, it might not.
The first test does this configuration in a way that relies on
vlan_default_pvid to assign the PVID. The second test disables that
autoconfiguration and configures PVID by hand in a separate step.
Signed-off-by: Petr Machata <petrm@nvidia.com>
Reviewed-by: Danielle Ratson <danieller@nvidia.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
This test relies on PVID being configured on the bridge itself. Thus when
it is deconfigured, the system should lose the ability to forward traffic.
Later when it is added again, the ability to forward traffic should be
regained. Add tests to exercise these configuration changes and verify
results.
Signed-off-by: Petr Machata <petrm@nvidia.com>
Reviewed-by: Danielle Ratson <danieller@nvidia.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
In a future patch, mlxsw will start adding RIFs to uppers of front panel
port netdevices, if they have an IP address.
At the time that the front panel port is enslaved to the bridge, the bridge
MAC address does not have the same prefix as other interfaces in the
system. On Nvidia Spectrum-1 machines all the RIFs have to have the same
38-bit MAC address prefix. Since the bridge does not obey this limitation,
the RIF cannot be created, and the enslavement attempt is vetoed on the
grounds of the configuration not being offloadable.
The bridge eventually inherits MAC address from its first member, after the
enslavement is acked. A number of (mainly VXLAN) selftests already work
around the problem by setting the MAC address to whatever it will
eventually be anyway. Do the same here.
Signed-off-by: Petr Machata <petrm@nvidia.com>
Reviewed-by: Danielle Ratson <danieller@nvidia.com>
Signed-off-by: Jakub Kicinski <kuba@kernel.org>
Add test for cases where bridge itself acts as a router interface, with
front panel port attached to the bridge in question.
In the first test (router_bridge.sh), VLAN memberships are not
configured in any way, and everything uses default PVID of 1. Thus
traffic in $h1 and $h2 is untagged. This test ensures that the previous
patches didn't break a currently working scenario.
In the second test (router_bridge_vlan.sh), a VLAN 555 pvid untagged is
added to the bridge CPU port, with that VLAN leaving the bridge tagged
through its sole member port. The traffic is therefore expected to come
out tagged at $h1. This tests the fix introduced in the previous
patches.
Signed-off-by: Petr Machata <petrm@mellanox.com>
Signed-off-by: Ido Schimmel <idosch@mellanox.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
