Higher speeds are only supported when PLL is enabled, but
the current driver doesn't enable PLL outside of stream
use cases, so better to set the lowest SPI speed accepted
by the entire device.
Move the current frequency set to the spi sub-driver so
the whole device can benefit from that speed.
spi-max-frequency property could be used, but ACPI systems don't
support it, so by setting it in the spi sub-driver probe
both Device Trees and ACPI systems are supported.
Signed-off-by: Lucas Tanure <tanureal@opensource.cirrus.com>
Reviewed-by: Charles Keepax <ckeepax@opensource.cirrus.com>
Link: https://lore.kernel.org/r/20211123163149.1530535-2-tanureal@opensource.cirrus.com
Signed-off-by: Mark Brown <broonie@kernel.org>
Up to now cs35l41_remove() returns zero unconditionally. Make it
return void instead which makes it easier to see in the callers that
there is no error to handle.
Also the return value of i2c, platform and spi remove callbacks is
ignored anyway.
Signed-off-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de>
Link: https://lore.kernel.org/r/20211020132416.30288-1-u.kleine-koenig@pengutronix.de
Signed-off-by: Mark Brown <broonie@kernel.org>
cs35l41 is often connected over I2C which is a very slow bus, as such
timings can be greatly improved combining writes where acceptable.
Update several points where the driver does multiple register writes
when a single one would suffice.
Signed-off-by: Charles Keepax <ckeepax@opensource.cirrus.com>
Link: https://lore.kernel.org/r/20210914141349.30218-3-ckeepax@opensource.cirrus.com
Signed-off-by: Mark Brown <broonie@kernel.org>