We are seeing a very low TCP throughput testing with some specific
tools. This is because for sub-frames of an AMSDU, MCBC flag in
mpdu_start may be not valid, and as a result those frames would be
dropped by kernel.
Add a new helper to get it from msdu_end. Also clean up original
helper since it is not needed any more.
Tested-on: WCN7850 hw2.0 PCI WLAN.HMT.1.0-03427-QCAHMTSWPL_V1.0_V2.0_SILICONZ-1.15378.4
Signed-off-by: Baochen Qiang <quic_bqiang@quicinc.com>
Signed-off-by: Kalle Valo <quic_kvalo@quicinc.com>
Link: https://lore.kernel.org/r/20230529081609.34567-1-quic_bqiang@quicinc.com
Low receive throughput is seen on WCN7850 because ADDBA related
parameters are not updated to firmware when receive ADDBA session starts.
Fix it by sending WMI_PEER_REORDER_QUEUE_SETUP_CMDID again to firmware
to update the ADDBA related parameters for chips which have false
reoq_lut_support in hw_params. For chips which have true reoq_lut_support
in hw_params don't need this command to send to firmware.
Tested-on: WCN7850 hw2.0 PCI WLAN.HMT.1.0-03427-QCAHMTSWPL_V1.0_V2.0_SILICONZ-1.15378.4
Signed-off-by: Carl Huang <quic_cjhuang@quicinc.com>
Signed-off-by: Kalle Valo <quic_kvalo@quicinc.com>
Link: https://lore.kernel.org/r/20230404070158.3368530-1-quic_cjhuang@quicinc.com
When a data traffic with size greater than 1500 is initiated,
say size 65500, it is sent as a set of AMSDUs (3 MSDUs)
in a MPDU.
These AMSDUs are incorrectly classified as multicast
and peer id gets changed, except for first msdu,
because of mcast_bcast bit derived from rx_desc
for every msdu received.
The mcast_bcast bit in rx_desc is only valid for
first msdu. Hence, add changes to derive mcast_bcast
only if it is a first msdu.
Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.0.1-00029-QCAHKSWPL_SILICONZ-1
Signed-off-by: Harshitha Prem <quic_hprem@quicinc.com>
Signed-off-by: Kalle Valo <quic_kvalo@quicinc.com>
Link: https://lore.kernel.org/r/20230320090400.30027-1-quic_hprem@quicinc.com
Firmware expects physical address in the reo entrance ring when MLO is
enabled and peer meta data in the queue_addr_lo for the non MLO cases.
Current implementation fills the physical address for the non MLO cases
and firmware decodes it differently which leads to SOC CSR region
access which is not related to firmware/MAC operation.
Fix this by sending only peer_meta data and destination indication bit
during non MLO case. This prevents firmware from invalid decoding.
Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.0.1-00029-QCAHKSWPL_SILICONZ-1
Signed-off-by: P Praneesh <quic_ppranees@quicinc.com>
Signed-off-by: Manish Dharanenthiran <quic_mdharane@quicinc.com>
Signed-off-by: Kalle Valo <quic_kvalo@quicinc.com>
Link: https://lore.kernel.org/r/20230317162056.20353-1-quic_mdharane@quicinc.com
Fix uninitilized variable warnings spotted during clang compilation.
Warnings:
drivers/net/wireless/ath/ath12k/mac.c:1076:8: warning: variable 'ret' is used uninitialized whenever 'if' condition is true [-Wsometimes-uninitialized]
drivers/net/wireless/ath/ath12k/dbring.c:272:7: warning: variable 'ring' is used uninitialized whenever switch case is taken [-Wsometimes-uninitialized]
drivers/net/wireless/ath/ath12k/dp_rx.c:2690:34: warning: variable 'i' is uninitialized when used here [-Wuninitialized]
Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.0-03171-QCAHKSWPL_SILICONZ-1
Reported-by: kernel test robot <lkp@intel.com>
Signed-off-by: Thiraviyam Mariyappan <quic_tmariyap@quicinc.com>
Signed-off-by: Kalle Valo <quic_kvalo@quicinc.com>
Link: https://lore.kernel.org/r/20221221105529.19345-2-quic_tmariyap@quicinc.com
ath12k is a new mac80211 driver for Qualcomm Wi-Fi 7 devices, first
supporting QCN9274 and WCN7850 PCI devices. QCN9274 supports both AP
and station; WCN7850 supports only station mode. Monitor mode is not
(yet) supported. Only PCI bus devices are supported.
ath12k is forked from an earlier version of ath11k. It was simpler to
have a "clean start" for the new generation and not try to share the
code with ath11k. This makes maintenance easier and avoids major
changes in ath11k, which would have significantly increased the risk
of regressions in existing setups.
ath12k uses le32 and cpu_to_le32() macros to handle endian
conversions, instead of using the firmware byte swap feature utilized
by ath11k. There is only one kernel module, named ath12k.ko.
Currently ath12k only supports HE mode (IEEE 802.11ax) or older, but
work is ongoing to add EHT mode (IEEE 802.11be) support.
The size of the driver is ~41 kLOC and 45 files. To make the review
easier, this initial version of ath12k does not support Device Tree,
debugfs or any other extra features. Those will be added later, after
ath12k is accepted to upstream.
The driver is build tested by Intel's kernel test robot with both GCC
and Clang. Sparse reports no warnings. The driver is mostly free of
checkpatch warnings, albeit few of the warnings are omitted on
purpose, list of them here:
https://github.com/qca/qca-swiss-army-knife/blob/master/tools/scripts/ath12k/ath12k-check#L52
The driver has had multiple authors who are listed in alphabetical
order below.
Co-developed-by: Balamurugan Selvarajan <quic_bselvara@quicinc.com>
Signed-off-by: Balamurugan Selvarajan <quic_bselvara@quicinc.com>
Co-developed-by: Baochen Qiang <quic_bqiang@quicinc.com>
Signed-off-by: Baochen Qiang <quic_bqiang@quicinc.com>
Co-developed-by: Bhagavathi Perumal S <quic_bperumal@quicinc.com>
Signed-off-by: Bhagavathi Perumal S <quic_bperumal@quicinc.com>
Co-developed-by: Carl Huang <quic_cjhuang@quicinc.com>
Signed-off-by: Carl Huang <quic_cjhuang@quicinc.com>
Co-developed-by: Jeff Johnson <quic_jjohnson@quicinc.com>
Signed-off-by: Jeff Johnson <quic_jjohnson@quicinc.com>
Co-developed-by: Karthikeyan Periyasamy <quic_periyasa@quicinc.com>
Signed-off-by: Karthikeyan Periyasamy <quic_periyasa@quicinc.com>
Co-developed-by: P Praneesh <quic_ppranees@quicinc.com>
Signed-off-by: P Praneesh <quic_ppranees@quicinc.com>
Co-developed-by: Pradeep Kumar Chitrapu <quic_pradeepc@quicinc.com>
Signed-off-by: Pradeep Kumar Chitrapu <quic_pradeepc@quicinc.com>
Co-developed-by: Ramya Gnanasekar <quic_rgnanase@quicinc.com>
Signed-off-by: Ramya Gnanasekar <quic_rgnanase@quicinc.com>
Co-developed-by: Sriram R <quic_srirrama@quicinc.com>
Signed-off-by: Sriram R <quic_srirrama@quicinc.com>
Co-developed-by: Vasanthakumar Thiagarajan <quic_vthiagar@quicinc.com>
Signed-off-by: Vasanthakumar Thiagarajan <quic_vthiagar@quicinc.com>
Co-developed-by: Wen Gong <quic_wgong@quicinc.com>
Signed-off-by: Wen Gong <quic_wgong@quicinc.com>
Signed-off-by: Kalle Valo <quic_kvalo@quicinc.com>
